M26X - 12 Relays Expansion Board
This board provides 12 electromechanical relays with NO (Normally Open) and NC (Normally Closed) connections. It can be easily mounted on control boxes using DIN rails and connect in a clean way to most motion controllers that emulate a parallel port.
This board provides 12 electromechanical relays with NO (Normally Open) and NC (Normally Closed) connections; this version can be easily mounted on control boxes using DIN rails and can also accommodate ribbon cables.
Connect with Clean and Simple Connections
• 12 Electromechanical relays with NO and NC positions.
• Use IDC26 to connect to the ESS, M16D (PoKeys), UC300ETH-5LPT, AXBB, C25XP, C94, or C76 (UC300ETH).
• Status LEDs on all relay connections.
• External Enable Pin (EN). The board has a pin that allows you to enable/disable all the relays at once.
• Can be powered and tied to the ENABLE line of the C76, M16D, C25XP (Rev4) C94, and MASSO G3 (M40 Board) through an IDC26 ribbon cable. *NEW*.
• Has terminals to allow access to available input pins.
• Din rail mountable.
• Pluggable Screw-On Terminals.
Write Your Own Review