POKEYS MOTION MOTHER BOARD
Designed for POKEYS ETH motion controller.
Built-in PWM-Based Speed Control and Two Built-in Electromechanical
Relays with NO and NC positions for spindle control.
The system monitors:
Safety Charge Pump.
Discrete Inputs and Outputs can be using with +5vdc TTL logic or 10-30vdc Logic.
Electromechanical Relay with NO and NC positions for general purpose (Port_2 16 or 17, jumper-selectable).
Microcontroller based SCHP.
Can be powered with a voltage between +10 and +30VDC.
Status LEDs on all input and Output connections.
DIN Rail mountable.
Pluggable Screw-On Terminals.
It is compatible with family of C34 connector boards that allow quickly connecting to popular drives connecting not just the step and directionsignals, but also the fault and enable signals.
|OPTOISOLATED DIGITAL INPUT TTL SPECIFICATIONS|
|On-state voltage range||2 to 5VDC or 5 to 30vdc|
|Maximum off-state voltage||0.8V|
|Typical signal delay||2.8uS|
|DIGITAL OUTPUT TTL SPECIFICATIONS|
|Maximum output voltage||5VDC|
|Maximum output current||50mA|
|Maximum off-state voltage||0.44 V|
|Maximum supported frequency||150KHz|
|Typical signal delay||10nS|
|Time of transition to high impedance state||12 s*|