hi,

i upgrade my 3018-mx3 controller bd to Pokeys57cnc PCB.

can any one help me, setup the spindle motor. im using this spindle PCB (DM-1105S-L12V 24V 48V 110V 400W DC Brush Motor Speed Controller)

this spindle controller 

Specifications: SUPPORT AC AND DC INPUT: The motor speed controller can support AC and DC input. Support 15-160V DC Input. support 12-110VAC input.

DRIVER THR DC MOTOR: It can driver the DC motor which voltage is 12V/24V/48V/110V, current 2Ω, power < 400W.

GOOD PERFORMANCE: Equipped with a fuse protection, Large heat sink reduce module heating, With power indicator, and more convenient to use.

PWM CONTROL: Except the board inside a PWM speed control, can also support an external PWM signal input speed control,

External PWM input requirements: level 3.5-12V VPP, the frequency of 1K-5KHZ, in particular apply in MCH3/MCH4 spindle speed control. 

APPLICATION: Dc pumps, fans, engraving machine spindle and other equipment dc motor speed for accurate speed control.

 so very thing is connect it,  when turn on the controller all stepper motors move and also the spindle.

i use (relay 1) output 1 to turn ON the spindle motor and Pin 17, GNDi  connect to the spindle controller PWN-1 PWN-2+.

but cant get it to work. ? 

thks

Pretty good post. I just stumbled upon your blog and wanted to say that I have really enjoyed reading your blog posts. Any way I'll be subscribing to your feed and I hope you post again soon. 

x trench run

I am deeply thankful for your commitment to research and providing well-crafted geometry dash content that is both informative and engaging, making the learning experience truly enjoyable.