You should be able to open your backup XML file and find the configuration there.

I'm running a Texas Microcircuit THC301d with a parrallel cable to com port 2. Everything was working fine til I charged my servo break out broard. I got it up and running, everything works fine except my THC. I think I changed a few pin numbers for com port 2. I should have recorded the numbers.

Does anyone have a installation manual for the THC301d or the input and output pin numbers?

Thank you.

Check these THC and Touch Sensor units:

https://www.cnc4pc.com/motion-control/torch-height-control/cnc4pc.html

Has anyone installed torch height control on a CNC PLASMA TABLE?  I have a Langmiur CNC PLASMA TABLE

I am looking for input on what i need to install ? I sent email to sales dept and waiting to hear back from them.