Philip, You can see the pinout of the boards in the manual for the C77 or C78: https://cnc4pc.com/ttl-terminal-board.html https://cnc4pc.com/rj45-board.html
Posted:
| |
Hy Arturo!
I have a question for the c76 with rj45 shield board. I wanted to know how i can set up the limits in uccnc or in mach3. Couse i don´t know the pins and ports for it on the rj45 shield board. I know where to plug in, but in the software it´s a little tricky.
Best regards Philipp reicher
Posted:
| |
You’ve written nice post, I am gonna bookmark this page, thanks for info. I actually appreciate your own position and I will be sure to come back here.
Posted:
| |
Philip, Thanks for your words. I think it would be easier to wire it using just a CAT5 cable with one end cut off so you have the pigtails. But I am a little unsure about wiring the fault an enable signals. If you need it, let me know and I will look into it.
Posted:
| |
Hy Arturo!
Thank you wery much for your fast answer!! Your service and contact is very very good. Many Shops here in Europe can learn of you how to handle customer. It sounds very good for the c34 for the JMC IHSS60-36-30. Is it possible for "now" to use the c34 for keling drivers 5056. It seems that it should fit. But i don´t know if the distance of the post fits. I mean without using the alarm+- and ped+- connections.
Kind regards from austria
Philipp Reicher
Posted:
| |
Philip, We do not have a C34 connector board for that driver/motor yet, but we are working on it and should be available by the end of February.
Posted:
| |
Hy Arturo!
I have a question for the C76 breakout board with the rj45 Connection for the axes. I want to connect JMC IHSS60-36-30 with rj45 cable. So i want to know wich rj45 breakout board i can use to connect it with a rj45 cable. I mean like the C34KL breakout board or anything else similar to this.
Kind regards
Philipp Reicher
Posted:
| |
Hy, thank you very much for your prompt answer. This sound very cool. So i want to order this two things for my cnc router.
Best regards from austria,
Philipp Reicher
Posted:
| |
Philip, You can use the C48 for this: https://cnc4pc.com/c48-ext-e-stop-probe-connector-board.html Check how it is wired in this controller: http://cnc4pc.com/Tech_Docs/CD_3.pdf Let me know if this answers your question.
Posted:
| |
Hello Arturo!
I have a question for the new breakout board C76. I want to buy it couse it looks very nice and everything is on it´s place and the rj45 connections to the stepper driver is cool. But i want to know if it´s possible to connect a 3d finder or a z-zero finder to this port and how it is wired. Thank you for your help.
Best regards
Philipp Reicher
Posted:
| |