Hello,

just curious if anyone is using ucCNC and what constant velocity settings you have set. I have switched from mach3 to unCNC, i am liking it so far but can't seem to get a consistent motion on corners the machine decel and accelerates on line segments of corners this affects cut quality a bit. I have cut the same part in mach3 an the cut quality is slightly better however i was surprised to see it had significantly more dross than when cut with ucCNC.

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
http://www.plasmaspider.com/viewtopic.php?t=23770
Wealth Management Platform Video

Thank you.