Looking for help in wiring ESS and C11GD Breakout Board by CNC4PC. There are a lot of information on C11 but not C11GD. The manual is technical and hard to understand for me. I am new to CNC and looking for any member here that can help me with this board. I made a diagram of my setup but not sure where to connect each components (some cheaper BOB have easy labeling but not this one), hope some members here wit

I bought a C11G in sept 2021 and got it working well but I built a new control cabinet to clean everything up and now can't get everything to work. I connect 5 volt to the power terminals and when I have them connected too power on lite on the Emerson light goes off but same power supply works on the smooth stepper so that's problem number 1, second problem is i had a wire on pin 16 since I hooked everything up and worked great, now I don't remember where that wire connected, 16 is one selected for charge pump...I have pictures of most everything but they never seem to show both ends of the wire. That would of helped. I can post pictures if anyone can help. Thanks in advance
Ed Duggin